Kleentek’s proposal to those involved in plastics.
ELC can eliminate oil oxidation products, which is impossible to do with filters, and maintain
the oil as clean as fresh oil. Thus, problem such as mentioned above are prevented.
Source: INJECTION MOLDING MAGAZINE (USA), February 1997
Variation ranges of injection molding conditions before and after oil cleaning with ELC.
| Item | Before oil cleaning | 800 hours after oil cleaning |
|---|---|---|
| Cycle time variation range | 2 seconds | 0.7 seconds |
| Injection time variation range | 1,73 seconds | 0.62 seconds |
| Recovery time variation range | 1,63 seconds | 0,78 seconds |
| Pressure variation range | 690 PSI | 94 PSI |
As a result, product failure rate was reduced to 1/6 of the pre-oil cleaning one.
